In order to be able to use this function correctly, it is necessary to adapt the configuration in Signal Management:Īllows you to toggle between two setups. In order to be able to use this function correctly, it is necessary to adapt the configuration in Signal Management:Īctivates the AUX input or the input of the extension card module (HEC / MEC / BEC) of the device when the push button is pressed. One of the following functions can be realized with the push button on the remote control:Īctivates the digital input of the device when the push button is pressed. Tick this checkbox if you do not want to use neither 'Control 1' nor 'Control 2' on your remote control. The virtual channels “Rear L Full” and “Rear R Full” are affected. This function is only available for devices with active VCP. In this mode, the virtual channels “Subwoofer1” and “Subwoofer2” are always controlled by the subwoofer volume if you activate them.Ĭontrols the volume of the rear channels. In order to have a maximum flexible configuration, it is necessary to activate VCP.Īs soon as VCP is active, you can use the routing of the virtual subwoofer channels to determine which output channels receive a controlled signal. If you haven’t activated VCP in the DCM menu, you can recognize the controlled channels by the fact that they are defined as “subwoofer” in the standard setting. With VCP-capable devices you can always recognize the controlled channels by the marking in the channel name: With the latter, the subwoofer volume control is activated by assigning the corresponding output channel in the IO menu as a subwoofer via its name: The configuration of output channels as a subwoofer differs between devices that are VCP-capable (crosslink) and devices that do not support VCP. like DVD players) do not have their own volume controls.Īdjusts the volume of the subwoofer channels. The other input signals remain unaffected.Īdjusts the volume of a digital signal source that is connected via the optical or coaxial SPDIF input. It is therefore not necessary to change the volume on the signal source itself. This is useful if your signal source does not have its own volume control.Īdjusts the volume of an AUX source or an extension card module (HEC / MEC / BEC). Depending on the product and its feature set, the selection may be limited.Īdjusts the volume of all output channels simultaneously.

Of course, it is not possible to assign the same function to both controllers. The rotary controls 'Control 1' and 'Control 2' can be assigned any of the following functions. This wired remote control has two rotary controls and a push button, the function of which you can determine yourself.

Dsp quattro no such volume